地下室通風措施施工有哪些？

發布人：http://   發布時間：2017-06-08 16:43:36

1.根據通風設備廠家介紹，地下室通風方式合理布置排風管及排風口，火災時兼作排煙風管及排煙口;地下一層考慮由車道自然進風，其它層由平時送風系統兼作火災時補風系統。

1. according to the ventilation equipment manufacturers, ventilation basement reasonable arrangement of exhaust pipe and exhaust outlet, fire smoke pipe and a smoke outlet; the underground layer considered by Lane natural ventilation, the other layer is composed of normal air ventilation system as fire system.

每個通風設備、排風、排煙及送風系統應設置豎井，進風口應設在地面潔凈處，若能與地下主樓有一定距離更好，其受火災氣影響會小。

Every ventilation equipment, exhaust air, smoke exhaust and air supply system should be provided with a shaft, and the air inlet shall be located on the ground clean. If there is a certain distance from the underground main building, it will be less affected by fire gas.

2.系統的劃分排煙系統防煙分區劃分應結合建筑防火分區來考慮，做到既有利于地下室通風系統兼作排煙系統，又不會出現排煙風管跨越枋火分區現象。所以使用一套通風設備時系統應滿足平時排風與火災時排煙要求。

Division 2. system smoke exhaust system should be combined with the zoning of building fire zoning into consideration, so as to have a smoke exhaust system for underground ventilation system, and will not appear across the fire smoke duct Fang District phenomenon. Therefore, when using a set of ventilation equipment, the system should meet the usual exhaust and fire smoke exhaust requirements.

3.另外，也可以進行通風管道安裝，普通離心風機即可滿足排風排煙要求，但大風量離心風機只能安裝在地面，占地較大，需要較大機房，高溫軸流風機為消防專用風機，也能滿足在280℃ 煙溫下運行30 min的要求，而高溫軸流風機體積小，一般可吊裝，若設機房面積也小，實際工程設計中，往往采用高溫軸流風機排煙。

3. in addition, can also meet the ventilation pipe installation, ventilation and exhaust requirements of ordinary centrifugal fan, but centrifugal air blower can only be installed on the ground, covers an area of large, large room temperature, axial flow fan for fire special fan, also can satisfy the operation of 30 min at 280 DEG C, the smoke temperature requirements high temperature, axial flow fan has the advantages of small size, can be lifted, if the room area is small, the actual engineering design, often using high temperature axial flow fan exhaust.