消防排煙管道的安裝使用標準

發布人：http://   發布時間：2017-12-14 15:52:24

1. 設備及配件進場
   1. equipment and accessories enter
   一般規定
   general provisions
   1》 主要設備應有裝箱清單、設備說明書、產品質量合格證書和產品性能檢測報告等隨機文件，進口設備還應具有商檢合格的證明文件。所有產品的型號、規格均應符合設計要求。
   1, the main equipment should have the packing list, the equipment instruction, the product quality certificate and the product performance test report and so on. The imported equipment should also have the certificate of qualified inspection. The model and specifications of all the products should be in accordance with the design requirements.
   2》設備安裝前，應進行開箱檢查，并形成驗收文字記錄。參加人員為建設、監理、施工和廠商等方單位的代表。
   2, before the installation of the equipment, the box should be opened and the acceptance text record should be formed. The participants are representatives of the units such as construction, supervision, construction and manufacturers.
   3 》設備就位前應對其基礎進行驗收，合格后方能安裝。
   3, the equipment should be accepted before it is in place, and the equipment can be installed after it is qualified.

   
   4 》設備的搬運和吊裝必須符合產品說明書的有關規定，并應做好設備的保護工作，防止因搬運或吊裝而造成設備損傷。
   4, the handling and hoisting of equipment must comply with the relevant provisions of the product instructions, and equipment protection should be done to prevent equipment damage due to handling or lifting.
   2 風管
   2 wind pipe
   1 》普通風管的材料品種、規格、性能與厚度等應符合設計和現行產品標準的規定。金屬風管的鋼板或鍍鋅鋼板的厚度不得小于表7.1.2的規定。
   1 "the material, specifications, performance and thickness of the ordinary wind pipe should be in accordance with the requirements of the design and the current national product standards. The thickness of the steel plate or galvanized steel sheet of the metal wind pipe shall not be less than that of table 7.1.2.
   鋼板風管板材厚度(mm)風管直徑或長邊尺寸b b 送風系統 排煙系統 b≤320 0.5 0.8 320
   The wind pipe plate thickness (mm) wind pipe diameter or long side B size B ventilation system and exhaust system B = 3200.5 0.8320
   檢查數量：按批抽查10%，不得少于1個。檢查方法：核對產品的合格證明文件、性能檢測報告、觀察或測試。
   Check number: no less than 1, 10% by batch. Inspection method: check the certificate of the product, performance test report, observation or test.